Trying out 4.0.3 medium trust build on my webhost and a problem occours that i havent got on my on testserver with the ordinary build.
When i run installwizard it works ok for a little while then it throws me back to the installwizard again. When i complete the wizard it works for a little while longer then the same thing happens. Ran the wizard and then asked a friend to surf to the url. This resulted in me seeing the page and my friend seeing the installwizard. Feels like some config isnt saved properly? Perhaps its just a matter of setting this manually?
Reverting to installwizard
Hi!
Trying out 4.0.3 medium trust build on my webhost and a problem occours that i havent got on my on testserver with the ordinary build.
When i run installwizard it works ok for a little while then it throws me back to the installwizard again. When i complete the wizard it works for a little while longer then the same thing happens. Ran the wizard and then asked a friend to surf to the url. This resulted in me seeing the page and my friend seeing the installwizard. Feels like some config isnt saved properly? Perhaps its just a matter of setting this manually?
Found the answer for this myself while searching around the forum, umbracoConfigurationStatus needed to be changed from blank to "4.0.3" in this case.
is working on a reply...
This forum is in read-only mode while we transition to the new forum.
You can continue this topic on the new forum by tapping the "Continue discussion" link below.