Sign in Register
Copied to clipboard

Flag this post as spam?

This post will be reported to the moderators as potential spam to be looked at


  • Joe Qureshi 3 posts 73 karma points
    Jun 20, 2017 @ 20:01
    Joe Qureshi
    0

    Umbraco not publishing changes unless application pool reset.

    When I make any changes to even empty sites the changes only go through once I have reset the application pool.

    Setting fcnMode to disabled works, however it takes much longer than it should.

    This is a clean install, using visual studio -> IIS express on windows 10.

    Copy Link
  • Alex Skrypnyk 5908 posts 22603 karma points MVP 4x admin c-trib
    Jul 14, 2017 @ 10:42
    Alex Skrypnyk
    0

    Hi Joe

    What is the code of your page? Can you share views code?

    Maybe some macro caching?

    Thanks,

    Alex

    Copy Link
  • Alex Skrypnyk 5908 posts 22603 karma points MVP 4x admin c-trib
    Jul 17, 2017 @ 09:33
    Alex Skrypnyk
    0

    Hi Joe

    Did you find what was the problem?

    Alex

    Copy Link
  • Joe Qureshi 3 posts 73 karma points
    Jul 24, 2017 @ 13:43
    Joe Qureshi
    0

    Sorry for the late reply.

    I tried multiple fresh installs on a windows 10 virtual machine (parallels) using a shared drive.

    0 code was added and the problem persisted regardless of whether I was doing it on Windows/Mac side.

    I followed a few guides on using Visual Studio & IIS Express to make it so my Mac side could use the same localhost.

    In the end I stopped using Umbraco and switched to a different CMS.

    Copy Link

  • This forum is in read-only mode while we transition to the new forum.

    You can continue this topic on the new forum by tapping the "Continue discussion" link below.

Please Sign in or register to post replies