Sign in Register
Copied to clipboard

Flag this post as spam?

This post will be reported to the moderators as potential spam to be looked at


  • Anthony Candaele 1197 posts 2049 karma points
    Jun 09, 2012 @ 16:14
    Anthony Candaele
    0

    cannot crop image

    Hi guys,

    I'm a bit puzzled here. I created a crop 'videoCrop' using the default image cropper in Umbraco 4.7.2 :

    then I defined a crop property on a custom media type:

     

    However, when I upload an image and try to crop it, I get an empty crop area:

    anyone familiar with this? 

    Thanks for your help,

    Anthony

    Copy Link
  • Jeroen Breuer 4861 posts 12138 karma points MVP 3x admin c-trib
    Jun 09, 2012 @ 16:57
    Jeroen Breuer
    1

    If you save the image again you should see the cropper. DAMP does this for you automatically if you have it installed.

    Jeroen

    Copy Link
  • Anthony Candaele 1197 posts 2049 karma points
    Jun 10, 2012 @ 08:55
    Anthony Candaele
    0

    Hi Jeroen,

    Just when I was about to start loosing it, I realised I defined the property with the Image Cropper datatype under the wrong tab ('Generic Properties' instead of 'Crop').

    On my Image Cropper settings, I also gave a wrong property alias in the Image Cropper datatype settings (I should have been 'umbracoFile' instead of 'videoCrop')

    Thanks for the advice,

    Anthony

    Copy Link

  • This forum is in read-only mode while we transition to the new forum.

    You can continue this topic on the new forum by tapping the "Continue discussion" link below.

Please Sign in or register to post replies